Before I send my frame off to be blasted,
I would like to replace the bracket that the
rear, lower A-arm mounts to.
This one has the center torn out and the DPO
welded across the shim.
I bought a new bracket, but I don't know how to get the old one off.
I have a cold chisel and BFH, a 3" cutoff wheel (air), and a 4" angle
grinder (electric).
I believe I can weld the new one on with my mig welder.
Oh, and I have the re-enforcing kits for the new brackets.
any help from those who have been there would be appreciated.
Brian
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~
NEW E-MAIL ADDRESS: borgstede@umsl.edu
Brian Borgstede I
Telecommunications Engineer, I '68 Triumph
University of Missouri, St. Louis I
Instructional Technology Center I TR-250
Phone: (314) 516-6433 I
Fax: (314) 516-5294 I
|