Ken,
If you want to get exotic, you can get a compressor and sensors from a
'79 Buick Riviera and rig them up so that the car automatically adjusts
the ride for its load. Of course, the Riviera pumped the air equally to
both shocks on the rear, but you could probably improvise a soultion for
that. Maybe even put 2 compressors on it, one for each side.
But then you would need to do the Dan Masters GM alternator conversion.
Regards,
Joe Curry
Ken Bertschy wrote:
>
> I read the article at VTR about curing Spitfire butt sag by installing a
> pair of corvette air shocks. Since my 77 Spit was suffering from this
> problem, it seemed like an economical solution to the problem and was well
> within my limited mechanical abilities. The install went smoothly but I
> ran both lines to a single air nipple and while the car looked fine, it
> sagged noticably to the left when I sat in it, making me look a LOT heavier
> than I really am. So, I installed seperate air valves and aired the
> driver's side shock slightly higher (20psi difference) than the passenger
> side. This cured the problem, except when my wife joined me and the car
> sags to the passenger side making my wife look...well, lets just not go
> there. So now I have to adjust the shocks constantly, depending upon load
> distribution. Is there an easy (cheap)way to do this? Is there a single
> valve that lets you distribute air to either/or shocks?
--
"If you can't excel with talent, triumph with effort."
-- Dave Weinbaum in National Enquirer
|