| To: | Triumph Newsgroup <triumphs@Autox.Team.Net> |
|---|---|
| Subject: | ATTENTION: Silicone Valve Cover Gasket Purchasers |
| From: | jmwagner <jmwagner@greenheart.com> |
| Date: | Fri, 25 Sep 1998 14:01:29 -0700 |
| Cc: | Cosmo Kramer <ebk@buffnet.net>, "'Amici Triumphi'" <fot@Autox.Team.Net>, Neil Revington <revingtontr@compuserve.com>, "Paul A. Carson" <pcarson@lcfh.demon.co.uk> |
PLEASE READ THIS IF YOU PURCHASED A SILICONE VALVE COVER GASKET FROM ME! Cosmo Kramer pointed an error out to me... The gasket came with a set of directions that included a valve tightening sequence... there is an error in the sequence! If you have kept these directions for any sort of reference, please make the correction: 8 - 1 6 - 3 4 - 5 7 - 2 <--- These were incorrect 1 - 8 <--- in the gasket manual! 3 - 6 5 - 4 2 - 7 This mistake happened because my Haynes TR 4/4A manual had a typo there... so you might also want to check your Haynes manual... page 48! No one has noticed the error until now! Thank you Cosmo. --Justin http://www.greenheart.com/jmwagner |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | That tiny little TR6 Clutch Bearing Sleave Pin!!, Wages, Jeffrey |
|---|---|
| Next by Date: | TR4/4A gounding (earthing), ArthurK101 |
| Previous by Thread: | That tiny little TR6 Clutch Bearing Sleave Pin!!, Wages, Jeffrey |
| Next by Thread: | RE: ATTENTION: Silicone Valve Cover Gasket Purchasers, Gernot Vonhoegen |
| Indexes: | [Date] [Thread] [Top] [All Lists] |