The Roll is of Flat vinyl and I guess it looks like it would cover the
Hoodsticks (Because I did order the Hoodstick cover). If that is the
correct piece then do I have to sew the edges? Does anyone know where I
might be able to get some directions on this. Thanks for all your help
>
>Either you are the lucky recipient of a shipping mistake (is it a whole
>roll?) or else you've got the boot cover.
>
>Is it just flat vinyl, or is there stitching or curves in it?
>
>The boot cover (squab cover) covers up the hoodsticks (soft top frame)
>when they are folded down. It stays on the car permanent-like. I'm
>pretty sure it's held on by the lift-the-dot-studs-trim at the rear.
>
>If you have a surrey top then maybe you can't use it.
>
>Also, if you have a retrofit TR4A or TR6 top then you also can't use
it.
>
>If I remember correctly, I think there are 3 pieces to the boot cover;
one
>flat one for the middle, and two "triangular" ones for the sides.
>
>If the piece o' vinyl is roughly the same width as the flat area in the
>rear of the cockpit, then that's where it goes.
>
>-Malcolm
>* There is a FAQ for this list! Its temporary home is:
>http://www3.bc.sympatico.ca/walker/triumph/trfaq.htm
>
>
|