George,
I installed one on my TR3A and do not have a problem with missing. I am,
however, concerned about the relatively short life reported by some. I hate
road side repairs.
Bob
>Well, I was thinking of getting an Ignitor setup for my TR3 (negative
>ground), but after reading a number of messages describing "missing", I
>think I'll go with the Allison/Crane unit.
>
>Trmgafun@aol.com wrote:
>>
>> In a message dated 98-09-23 10:16:27 EDT, you write:
>>
>> << I put one on my '76 TR6. The car started great, but developed a miss
>> under load that I could not fix (until I put the points back in). I also
>> fitted one to my neighbors '75 TR6. Same result. The 75 & 76 TR6s have
>> an internal ballast resistor (in the harness). I never did figure out
>> whether or not that was a cause of the miss. I would fit the unit back on
>> my car if I could find the cause of the problem.
>>
>>
>> Larry Miceli
>> '76 TR6
>> '73 Stag
>> '66 Herald >>
>>
>> Larry,
>>
>> I have the same miss with my newly acquired '76 TR6. It also has electronic
>> ignition and the miss is most noticable when taking off from a dead stop.
>> Maybe the root of the problem is the same as yours. I'd sure like to get it
>> solved.....
>>
>> Scott Helms
>> N. Indiana
>
>--
>George Richardson
>'57 TR3, TS15559L - painting and reassembling....
>http://www.merlingroupinc.com/tr3.htm
|