triumphs
[Top] [All Lists]

Re: TR6: stumbling under load, Who is up to the challenge?

To: "Jack R. Clark" <drjclark@mindspring.com>
Subject: Re: TR6: stumbling under load, Who is up to the challenge?
From: Jerry <lensman@erols.com>
Date: Sat, 19 Sep 1998 09:20:36 -0400
Cc: triumphs@Autox.Team.Net
References: <3.0.1.32.19980918231710.006d5774@pop.mindspring.com>
You didn't list it as being checkerd or replaced.  Check out your distributor
cap.  Look for scoring and cracks.  Also check the rotor and the rotor contact
point.  I had similiar problems with my GT-6 and replaced these items and all is
well.

Jerry - 1968 GT-6 MK1



Jack R. Clark wrote:

> Listers,
>
> I have a continuing problem. I am still getting some
> stumbling when accelerating hard, or accelerating
>  in high gear at lower rpms. This only happens after
>  the car has warmed up to top operating temp.
>
> The following is a list of what I have done:
> '74TR6  68,700 miles
> 1. Replaced points, condenser, plugs (bosch platinum),
>    plug wires, Lucas sports coil, (connected without
>    the ballast resistor in effect), plug gap at .035
> 2. Rebuilt carbs, Grose jets, air flow equalized,
>    mixture a little rich.
> 3. Using SU-Zenith Damper oil from Victoria British
> 4. Timing using strobe is at 10 degrees BTDC with
>    vacuum retard removed and 3-4 degrees ADTC with the
>    vacuum connected.
> 5. Replaced all major vacuum lines
>
> Observations:
> a. when rebuilding carbs, one Temp Compensator plunger
>    moved freely, the other would move, but tended to bind
>    along the walls of the TC housing. I did not touch the
>    adjusting nut! Just cleaned and replaced.
> b. Again, no problem initially, only when normal temp is
>    reached
> c. Idle is a little rough, just a jerk every now and then.
> d. Runs at speed better than it ever has, pulls up to
>    100 mph with more to spare,  and I can drive in a way
>    as to prevent the stumbling, but I would like to fix
>   the problem.
> e. Noticed that no vacuum in the line  coming from the
>    thermostatic switch  on the radiator hose(clogged up?),
>    so I connected directly to the small line feeding the
>    switch. Vacuum retard works well, but do not know if
>    the vacuum is too strong, or too weak.
>    Since I have replaced everything else, I feel it may
>    be the Temp compensators. Or is it the thermostatic switch? (none    of
> the big three have them in stock) What do you think?
>
> Who ever can figure this one out is definitely the King of e-mail diagnosis!
>
> Thanks
> Jack '74 TR6 CF23352




<Prev in Thread] Current Thread [Next in Thread>