In a message dated 98-09-09 14:30:26 EDT, you write:
<< Hi, Don
> Do you have any information re the fitment of the 3.7-1 and 4.1-1 rear
> axle ratios?
> Was one factory spec for Overdrive and the other for non overdrive?
> Or was it possible to get the 4.1-1 on a non overdrive car as standard
> equipment?
Sorry for the delay in coming back to you. The situation is as follows:
The TR4 was normally supplied with a 3.7:1 axle for overdrive and
non-overdrive. A 4.1:1 ratio was also available for special order but
overdrive had to be fitted as well. It was not possible to order a 4
with a
4.1 diff and no overdrive. Hope this clears up the query
Regards
John
>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>>
Thanks Don
This is about what I thought.
A bit scary, my train of thought mirroring the factory.
Ken Nuelle
58 TR3A
62 TR3B
64 TR4
|