FWIW, I got my floor panels amd rocker panels (inside & out) from Moss at a
good price, I would recommend that you keep hte body on the car, measure the
distances between A and B posts, across the fron and back of the doors from
side to side and then weld cross braces from the top of the A&B posts to the
bottom of the door frames, leaving room tto mount the doors and cross braces
from the left B post to the right B post in an "X" fashion. Make sure the car
is on level ground. Then start cutting the panels and sill from the body. I
would definitely recommend using new panels. Also, while you are at it, after
you remove the floor panels, take a good look at the fire walls. Good Luck.
Bob Roberts
TR$ 35411CT
|