How the heck do you remove the frozen ball joints on a TR3? I bought a
pickle fork type remover, beat /pried on it with on results except to
further damage the grease boot. I was planning to replace the boot and
upper arm bushings. I even tried heating it with a blowtorch, with no
luck. I ended up removing the bolts at the top of the a-arm and replacing
the bushings via the back door, but still have to replace the boot on the
ball joint. Any suggestions other than C-140?
Richard Triplett
Technical Services
Midland, Texas
915-683-2781
(I joined a think tank, but it went septic)
|