In a message dated 98-07-27 16:23:30 EDT, shmitty99@hotmail.com writes:
> Oh and I'm going to install a
> lucus sport coil so some info on how to bypass the ballast resistor
> would also be helpful.
Ryan,
On one end of your ballast resistor, you will find two white/yellow wires, and
on the other end, you will find one white wire. Just remove these three wires
from the ballast resistor and connect them all together. Discard the resistor.
Dan Masters,
Alcoa, TN
'71 TR6---------3000mile/year driver, fully restored
'71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
http://www.sky.net/~boballen/mg/Masters/
'74 MGBGT---3000mile/year driver, original condition - slated for a V8 soon
'68 MGBGT---organ donor for the '74
|