| To: | Lftlesl@aol.com |
|---|---|
| Subject: | Re: Removal of sending unit |
| From: | MRobe33243@aol.com |
| Date: | Mon, 1 Jun 1998 17:56:58 EDT |
| Cc: | triumphs@Autox.Team.Net |
I believe the TR4 has the same unit; six screws hold the unit atop a gasket. If you have removed the screws, chances are bonding has occurred. Recommend you use a putty knife to carefully pry up the unit. The sending unit's float is at an approximately 30o angle to the seal. Bob Roberts TR$ 35411CT |
| <Prev in Thread] | Current Thread | [Next in Thread> |
|---|---|---|
| ||
| Previous by Date: | TR6 Zenith mixture "adjusters", Andy |
|---|---|
| Next by Date: | RE: TR6 Zenith mixture "adjusters", Peter Zaborski |
| Previous by Thread: | Removal of sending unit, Lftlesl |
| Next by Thread: | Re: Advise on TR4A Windshield Wiper Stopping Position, DANMAS |
| Indexes: | [Date] [Thread] [Top] [All Lists] |