Folks,
Thanks to all who offered advice on my rebuild kit. I went ahead and
used it last night based on several of the responses. All the seals fit
properly with the exception of the small o-ring that is sandwiched
between the reservoir and the body, which is too large. Oh, well.
>From all I've gathered, PBR is a reputable company with a reliable
product. It would appear that the kit from VB should be avoided.
Time will tell whether I've made the right decision. At least I'm
switching to DOT 5 so the paint won't disappear if it does leak. ;-)
D.
yesterday I wrote:
>I just received a brake master cylinder rebuild kit that was made by
PBR
>Automotive in Australia. ISTR the prevailing wisdom some time back was
>that the rubber bits from Down Under were less than what one would
>expect. Has anyone had any experience with this company, or should I
>send the kit back as a matter of course?
--
Dee Jackson Ph. 336-547-5007
Gilbarco Inc. Fax 336-547-5234
Greensboro, NC e-mail dee_jackson@gilbarco.com
|