I have decided the driver's floorpan is beyond redemption. M, VB, & TRF
all list replacements for around $200. Post-60000 appears not to be
available and M & TRF both say that Pre-60000 can be used with a little
"coaxing" or re-working.
My questions are:
How much coaxing am I looking at?
Is the VB offered one basically the same?
Is there another source that might have the correct pan?
Is there any difference in quality, fit, etc between the three?
Any suggestions on the install. It appears to be straightforward,
except for whatever amount of fitting it takes.
As usual, the knowledge and guidance put forth by the list is greatly
appreciated.
Later,
Carl F. Musson,
'58 TR3A - TS25264L - borrowing the engine/tranny from
'60 TR3A - TS81802LO - body off restoration in progress...
Tampa, Florida (USA)
E-Mail: Musson@arts.usf.edu <mailto:Musson@arts.usf.edu>
http://www.arts.usf.edu/~musson/triumph/
<http://www.arts.usf.edu/~musson/triumph/> (Pics of the new project
ready to be scanned...)
|