MRobe33243@aol.com wrote:
>
> OK, I'm getting down to the nitty gritty, the floor pans.I have read from the
> list about "body integrity"welding between the post, frame-bolt hole
> alignment, etc (which scares the hell out of me). One thing that bothers
> me iis: do I cut the panels out now, or wait for the new ones to ensure that
> the cut is on the line (I think I answered that one after reading the
> question) Any way your input will be greatly appreciated>
>
> Bob Roberts
> TRA 35411CT
After my experiance with my 72 spit, I would wait till the new ones
arrive. Drop them in as close as you can and use a piece of chalk to out
line. Make real sure you leave some extra, it's a whole lot better to
take more off than try to make a mig bridge a gap of two inches !
Been there Done that.
|