Thanks for the prompt reply James!
jc> The reason it's leaking is not because of lack of
jc> torque, but to much pressure underneath. Holding the
jc> head up.
Hmmm... I don't understand this, could you please elaborate?
jc> I can tell you that I did exactly the same thing, you said
jc> you only lost one washer, I would probably have been OK if
jc> you had lost all the washers.
Oops. I should have elaborated here. The washer was related to the
exhaust system (which I had to partially remove in order to lift the
head+exhaust manifold off). This isn't a big deal. I'll try to replace
it soon.
Thanks again,
Anthony
--
Anthony Green Cygnus Solutions
Sunnyvale, California
|