Hey Adam,
I tried to do the same thing a few months ago. Got about as far as you did.
The advice I got was to take it to someone with a hydralic press.
100 hours of body work! In NY labour is $50-$60 an hour. That come to
$5,000-$6,000!!! That is the cost of a new body shell from BMHT. What did
this guy do for ya?
Later,
JHD IV
>>> Turner & Turner <turner@turner.se> 02/10 6:55 AM >>>
Trying to replace the side diff seals, I tool the four bolts off and
eased out the shaft / bearing / key / plate assembly then undid the big
nyloc nut. Now though, I can't get the assembly apart to get at the oil
seal.
I even tried (shame) bracing the square plate and hitting the end of the
thing with a hammer -- no dice.
Any suggestions as to how I proceed?
Adam Turner
'74 TR6 (just been billed for 100 hours of bodywork rebuild - OUCH)
|