TeriAnn,
I can't guarantee that my 3a is completely stock, but the carb linkages
seem to work relatively well. Unless you consider the toe adjustable idle
a bug instead of a feature.
But for what they're worth, here are the measurements I was able to get:
>From the floor to the top of the bolt, 1 inch. From the top of the bolt to
the middle of the strike plate on the accelerator pedal (where it touches)
1 and 1/4 inches. That would make it 2 and 1/4 to the floor.
Hope this helps, if you're headed up to the penninsula, you are more than
welcome to come see for yourself.
Bob
>I want to reset the carb linkage geometry on my TR3A.
>
>I need two measurments from someone who has a completely stock, properly
>adjusted TR3 carb linkage.
>
>Could someone please tell me:
>
>- There is a bolt that is used as the bottom stop for the throttle pedel.
> Could someone please provide me with the length of the exposed part of
>the bolt (ie: throttle down height)
>
>- The distance between the tip of the throttle pedel and the hole in the
>floor for the throttle down stop bolt (ie: throttle up height).
>
>THANKS!!!
>
>TeriAnn Wakeman
>Santa Cruz, California
>
>NOTE NEW E-MAIL ADDRESS twakeman@cruzers.com
|