Mike
I don't know if this will help but put the trans into a gear. Then turn
the rear while pushing it and it will stop when it engaged the splines.
Then move it around until it catches the pilot bushing.
Oh yeah did you check to be sure the splines matched your tranny? You may
have the wrong plate(lets hope not though.)
----------
> From: Michael Holmes <mholmes@sirius.com>
> To: triumphs@autox.team.net
> Subject: Refitting clutch on '79 Spitfire.
> Date: Tuesday, December 23, 1997 10:02 AM
>
> I've replaced the clutch plates and am now trying to refit the
> bellhousing and gear box back onto the engine. I've used a dowell as a
> centering tool for the driven plate. I can't seem to get the splines of
> the shaft into the splined opening in the clutch plate. Any
> suggestions? Most appreciated. My e-mail is above.
> Thanks again.
>
> Mike.
>
>
|