On Nov 24, 7:20am, Doug Mathews wrote:
When I did this, the directions with the kit said to insert the distance piece
last. I think a better way is to put it in first, followed by the spring
plate, and the locking plate last. The locking plate should slide right in and
lock into the tabs in the spring plate. The Bently manual has some info also.
After all is installed (don't forget the green grease) the cylinder is firmly
mounted and slides easily in the slot.
> Subject: TR4-TR6 Rear Brakes
> I replaced both rear brake cylinders on my 64TR4 and have a question about
> the "distance piece". There are 3 pieces that hold the cylinder in place, a
> "spring plate", a "locking plate", and the distance piece. There was no
> problem with the spring plate and locking plate, but the distance piece I
> could not get in on either side. The question is are they needed with the
> "replacement" cylinders.
--
___________________________________________________
Jeff S. Hapke Motorola CIPG Arlington Heights, IL
|