triumphs
[Top] [All Lists]

Delurking and a Spit rear spring question

To: triumphs@Autox.Team.Net
Subject: Delurking and a Spit rear spring question
From: kinderlehrer@mindspring.com (Kinderlehrer's)
Date: Sat, 20 Sep 1997 16:05:04 -0400 (EDT)
Stuart,

There is a place in San Jose called Triumphs Only run by a guy named Wayne
Bier. It's at 1718 Stone Ave #F, phone (408)947-7766.  He has a good supply
of new and used parts.  If you're at Stanford, it's not too difficult to
get to, but thay are not open weekends.

Bob

>X-Sender: friedman@pobox4.stanford.edu
>Mime-Version: 1.0
>Date: Fri, 19 Sep 1997 09:38:40 -0700
>To: triumphs@autox.team.net
>From: stuart l friedman <friedman@leland.Stanford.EDU>
>Subject: Delurking and a Spit rear spring question
>Sender: owner-triumphs@autox.team.net
>Precedence: bulk
>Reply-To: stuart l friedman <friedman@leland.Stanford.EDU>
>X-Info: To unsubscribe send mail to majordomo@autox.team.net with nothing but
>X-Info:    unsubscribe triumphs
>X-Info: in the body of the message
>
>Greetings!  I've been lurking on the list for a while as I recently bought
>a 1970 Spitfire MkIII from fellow list reader Tom Monson.  You might recall
>the thread about the SMOG folks thinking this car had the wrong carb.  So
>far I've had great fun tooling about with the top down.  From what I've
>read on the list, it seems that I have perhaps slightly less than average
>number of bizarre electrical 'features.'  (turn on hi-beams, lose the
>instrument lights--hmmm.  that'll have to wait for a nice rainy week this
>winter.)
>
>The only pressing repair is replacing the rear spring (and a bearing in the
>differential while I have things apart--hopefully that will get rid of some
>rear end noise the PO has chased for a while).  The PO suggested I upgrade
>to the swing spring from later models.  Is there someone out there who has
>done this who might share some experience before I begin wrenching?  A
>recent post seemed to indicate that this was a simple bolt on modification,
>whereas the little green competition preparation booklet provided by the PO
>describes some modifications to the spring.
>
>Also, are there any San Francisco bay area readers with any suggestions for
>local parts suppliers or maybe recyclers with some spits?
>
>Thanks,
>
>Stuart
>
>******** note new area code ********
>-------------------------------------------------------------------------------
>Stuart L Friedman                       email:  friedman@leland.stanford.edu
>Center for Materials Research             lab:  650.723.3209
>McCullough 250                         office:  650.723.4768 (room 226)
>Stanford University                       fax:  650.725.5457
>Stanford, CA  94305-4045
>



<Prev in Thread] Current Thread [Next in Thread>