Mark Stahlke wrote:-
> I'm planning to fabricate a wooden radio blanking plate to match the
walnut
> burl dash in my 71 TR6. Since a PO had enlarged the radio hole, I figure
I can
> fit a couple of extra gauges in there. I'm thinking of a volt meter and a
> clock. Does anyone have any suggestions on a source for a clock that woul
> match the Smiths gauges?
>
> Thanks,
> Mark
>
>
Mark
Why not pick up a clock from a MkII Triumph 2000 or 2.5 PI? The guages used
were essentially same as the TR6 (especially on the PI) so the clock would
be in keeping. It is a little larger than the oil pressure, temp and fuel
guages though.
Should be able to get one from Rimmers in England.
Email: greed@wave.co.nz (Home)
sys_dwg@cmosaf.telecom.co.nz (Work - AlphaStation)
david.greed@telecom.co.nz (Work - PC)
|