tom.omalley@channel1.com wrote:
>
> Hi Shane!
>
> The resistence of the ballast wire will be about 1.8 ohms.
> It's connected to one of the two white wires that come off your
> ignition switch connector under the dash. The actual point on the
> harness where these two wires are crimped together will probably be
> exposed. It may look like a DPO bodge...it's not...it's a Triumph
> bodge. :-)
> Hey Fellas,
Where can I get a piece of resistance wire for my rusty old
TR6 that I bought a couple of months ago?
It looks like it must have shorted out and turned into a toasted
marshmellow. Won't run in on position but runs good on start or with a
jumper battery to coil. Switch might be bad also - I haven't even hecked
that yet.
I will probably replace the complete harness when I restore it in a
couple of years after I retire and move to NC next year. All the wires
are the same color (under hood paint job)
Joe Worsley
80 TR8
72 TR6 (sleeping until restoration)
Tupelo, MS
|