In a message dated 97-07-18 10:20:21 EDT, dynamic@transport.com (Pete &
Aprille Chadwell) writes:
> I don't know if this is really the best spot in terms of heat, but stamped
> into the left inner wheel arch, in the vicinity of the distributor, there
> is a large flat spot, in a slight depression. It is (without looking at
it
> or measuring) something like 4 inches by 6 inches... in that neighborhood,
> maybe even a little smaller. This is where I mounted mine, and it has (so
> far) not created any problems. This little flat spot looks like it was
> made just for this purpose.
FWIW, I mounted mine in the same location. It's been there for about 5 years
now, with no problem. Like Pete says, it looks like it was made for that
purpose!
Dan Masters,
Alcoa, TN
'71 TR6---------3000mile/year driver, fully restored
'71 TR6---------undergoing full restoration and Ford 5.0 V8 insertion - see:
http://www.sky.net/~boballen/mg/Masters/
'74 MGBGT---3000mile/year driver, original condition
'68 MGBGT---organ donor for the '74
|