triumphs
[Top] [All Lists]

FW: Re: Need air pump/rail for 'TR6

To: triumphs
Subject: FW: Re: Need air pump/rail for 'TR6
From: Mark J Bradakis <mjb>
Date: Thu, 10 Apr 1997 12:24:12 -0600 (MDT)
[BOUNCE triumphs@Autox.Team.Net:    Non-member submission from [Mike Ginter SA 
<mike@stortek.com>]]

     Date: Sun, 30 Mar 1997 10:28:38 -0700 (MST)
     From: Mike Ginter SA <mike@stortek.com>
     Subject: Re: Need air pump/rail for 'TR6


british Motor Works ( I think is the name, I'll check if you would like),
made an air rail for my Spitfire that just plain SUCKS.  But it did get
the job done.  Anyway, it is possible to make an air rail out of copper
pipe and whatnot.  In fact, if you end up making a nice one, I'll
commission you to make me one that actually looks decent.  Where are you 
located anyway?  I'm in Thornton.

Mike
79 Spit

On Sun, 30 Mar 1997, Scott W. Paisley wrote:

> I'm hoping someone out there has an air pump and an air rail for
> a '75/76 TR6.  I'm in the process of going through Colorado
> emissions and they require that I have that stuff on the car even
> though it passes the tail pipe test. !  It's possible that I could
> get a waiver, but I figure I should just get the stuff on the car.
> 
> I'm going to puchase new valves (for the air pump stuff) as they are
> important pieces for the air pump to function correctly.  I'm about
> to put new valves in the head too, but that's another story.
> 
> Has anyone used compression fittings and Stainless tubbing from a 
> hardware store to make an air rail?  I think it could
> be done and would be a lot less than $175-$200 for a new rail.
> 
> Has anyone used an aftermarket air pump?  What fits?
> 
> Cheers and ADVthanksANCE!
> 
> -Scotty
>  '75 TR6 (getting ready to pull the head due to bad valves) :-(

<Prev in Thread] Current Thread [Next in Thread>
  • FW: Re: Need air pump/rail for 'TR6, Mark J Bradakis <=