I'm finally getting around to installing the heater controls. I'm getting
kinda tired of wiping the inside of the windshield while I drive whenever it
rains. I figure that the fan has got to help at least a little.
So the question is how is the motor and switch wired? My wiring diagram shows
a green into the switch and then black from the switch to the motor. However,
my switch has two speeds with one green/yellow wire with a male connector
attached to the first speed strip. Out of the heater box there is a
green/white with a female plug, light green/yellow(?) with a female spade
connector, and black. So I assume that the green/white from the box plugs into
the green/white on the switch, and then the light green/yellow(?) plugs on the
high speed strip, with the black going to the motor. Does that sound right?
Part of the problem is that I'm having a hard time with the wire colors as they
are faded.
TIA and Happy Holidays!
Bill M.
'70 MkIII Spitfire
|