On Dec 20, 10:09am, Barry Schwartz wrote:
<lotsa good advice snipped>
> But you will have to weld shock mounting structures similar to what
> the GT6 uses inside the wheel wells.
Actually, there's another solution. TSSC sells conversion brackets
that mount to the frame and extend the shock pickup points out to
almost the same place. They use a slightly shorter shock, but
transfer the load to the frame rather than the sheet metal of
the body. Id' think that these would be worth looking at,
especially for a Spit-6 conversion.
cheers,
John Lye
rjl6n@virginia.EDU
http://avery.med.virginia.edu/~rjl6n/homepage.htm
|