Hello to all the sheet metal gurus out there in LBC land. I am
presently in the process of replacing the floor pans in my 75 spit.
I can buy the panels from either VB or TRF. The question is which
panel is a better panel and which panel goes further up the center
tunnel? Got a lot of rust and want to have a good daily-driver. I
know that the car is not show quality, but I like to have my feet
inside, not outside like the Flintstones!
Actually, the little beast is a rustbucket. Want to do a frame off
restoration. Need to know if the floor panels and sills should be
replaced before removing from frame or after removing. This is a
winter project, and quite possibly a summer project, and quite
possibly a winter project. Not in a hurry to get it done, just done
right!
Thanks in advance,
Dan
|