In a message dated 96-08-03 17:02:10 EDT, Bitparts@aol.com writes:
<< am installing my Moss provided tonneau and soft top on my 63 TR4. Which
way are the lift the dot fasteners oriented. Does the dot end face the edge.
Or does it parallel the edge ie. the writing is perpendicular to the edge.
Thanks!
>>
This is important. The fasteners should be placed so that you can pull
parallel to the line of the fenders, in other words you can grab the forward
edge of cover or hood and pull toward the back of the car and around the rear
rather than up. Also reverse the orientation of the dots halfway around. The
reason is that it is difficult to get your fingers under the lip of the
cover/hood. This greatly increases the speed of installation from the
tonneau cover to the hood when there is a storm coming! Hope this is clear
-- if not please shout.
Art Kelly 64 TR4 CT 33118L (original owner)
|