>
>
> Just going through the rebuild on my '74 TR6 motor (body is a '72) and
> I can't find any mention of assembled clearance between main bearings
> and crank and rod bearings and crank in the Bentley manual. I intend
> to check using plastigage just to make sure machine shop did things
> correctly.
>
> Can anyone offer advice?
>
> thanks in advance.....
>
> Mark
> mmanasas@jjprayc1.jnj.com
> '72 TR6 CC77356L
>
>
>
>
>
Mark,
Without going into a lot of detail, check page 104 of your Bentley manual.
Clearences should be between .001 and .0027 with "Plastigage".
Regards,
Tony R.
"GT6s"
###
|