>
>It is time for some new foam in my seats of my GT6+, but....I have my doubts
>as to where the seats orgianally come from = and hence as to what foam to
>order/find.
>
>The seats can be tipped forward, but cannot recline. I would have thought
>nothing of it, except for the fact that when I try to tip them forward, the
>movement is constrained by the roof (seats have SO high backs) so they only
>tip about four inches from the bottom. Therefore I doubt if they were
>actually out of a coupe, but perhaps out of a convertible? There is no knee
>pads as on my friends GT6 Mk. 3, but I have transmission padding, which
>increases the side-support considerably (=what is I like the most about the
>seats). The seatbelts are two-point fixings, and hook onto a ring bolted
>through the transmission tunnel and the floor of the car. The seat bottom
>can come out, is snapped on with two snaps in front underneath, and one in
>the back. Finally, the do not have seperate headrests!
>
>Anybody can figure out what seats these are from my description? Any
>suggestions would be greatly appreciated,
>
>Thanks y'all,
>
>Milton
>
Milton,
You have just described the seat in my 69 GT6+. Since I bought this car
in a junk yard, I can only assume they are correct. Looking at the
drawings in the Vicky Brit catalogue sort of confirms it.
Hope I've helped.
Best Regards,
Tony R
"GT6s"
###
|