I am looking for anyone kind enough to give me a roadmap for rebuilding
the front steering on a tr3a (ts30000 something)
methods, checking, tips on disassembly & assembly, caveats, etc. would
all be useful.
of course at this point i have considerable play in the steering. i did
replace the idler pivot casting a couple of years ago, but the pivot arm
needs replacing as well, based on the amount movement. i have the tie
rod ends in stock. i know that there is some adjustment in the steering
gears, but i think i am at the limits of this adjustment.
i would prefer doing this work without removing the front apron, but if
it is recommended, i will.
help joe out, please!! dont feel sorry for me. i had the body off in
the mid 80s and short cut this obvious requirement. it was not a driver
when i bought it, but i know better that to skip something important
like steering, especially on this design.
this might be good for the whole list. i havnt seen it come up during
the short time i have been subscribed.
thanks
joe alexander
rw20232@deere.com
|