>
> So, I've given up on getting my PDWA switch not to leak so I slammed a bolt
> in where the switch goes (and it hasn't leaked a drop). My question: how do
> I connect the wires to deactivate the warning light. I know this is wrong,
> but it's temporary.
I wouldn't lose sleep over it...
>
> The switch was disconnected when I got the car otherwise I could probably
> figure it out.
>
Doesn't the bulb only light when the switch closes and grounds the circuit?
Pulling the wire off the switch ought to stop it from lighting, except when
grounded through the oil pressure switch (acts as a big bright oil pressure
light).
Pete
|