Why use a veneer at all, instead of just hardwood? Is it because
you wanted the burl, which was only available in veneer?
I will be installing a wood dash in my TR4, and expect to use
just hardwood, no veneer. What thickness stock should I use?
Also, what did you use for a template for cutting holes? just
the old dash? Is there any special attachment hardware that needs
to be ordered?
Thanks!
Charlie Farwell 1962 TR4 CT3852L
cyf@dr.att.com
On Jun 20, 7:04am, Limno-Tech Inc. wrote:
> Rob Pennington wrote:
>
> - Fancy veneer looks great, but it is more difficult to use and a *lot*
> more expensive than the straight grain stuff. A 1.2x4 ft. sheet of burl
> set me back about $65. A similar sheet of straight grain walnut might cost
> $10-15.
>
|