You might also check...
Years ago I still had my original "yellow stripe" vacuum hose on my
servo. Back behind the air cleaner where you couldn't see it, it had
become "soft". When it got hot it sucked in and closed off the vacuum
to the servo until it cooled slightly. Boost was intermittent.
Gary
> On 04/26/2022 11:10 AM Wayne Pierzga via Tigers <tigers@autox.team.net> wrote:
>
>
> Hi Jay
>
> I was not aware you were using SS braided flex lines. If I recall these use a
> 'plastic' tube to carry the brake fluid. I donâ??t think these tubes
> delaminate/collapse like OEM rubber as they deteriorate.
>
> So, I have another suggestion you may want to investigate. Is there an
> in-line vacuum check-valve between the carb and brake booster? If so this may
> be sticking and could be the source of the intermittent problems you describe.
>
> Cheers
> Wayne
>
> -----Original Message-----
> From: Jay [mailto:jay.laifman@gmail.com]
> Sent: Monday, April 25, 2022 5:34 PM
> To: Tiger List Serve <tigers@autox.team.net>
> Subject: Re: [Tigers] Brakes biting
>
> Iâ??m starting to suspect the hoses more. There was another incident that
> was a bit different, and now that I think of it, points more to the hoses.
>
> As I said before, as I was coming to a stop, with my foot on the brake, at
> the last second before coming to a complete stop, it seemed the brakes bit a
> little harder - like I pushed the brakes a tiny bit, even though I didnâ??t
> at all.
>
> My initial assumption was that there was a bubble in the rubber hose,
> increasing pressure. But I discounted that since it stopped immediately when
> I lifted the pedal. When I have heard about this before, I recall that the
> bubble kept the pressure up even after the pedal was released. But every
> situation is different.
>
> This other incident was also at very low speed, just after I lifted the
> brakes and was coasting forward, I got a feeling like I was taping on the
> brakes repeatedly and the wheel was chirping. It was very strange. I
> donâ??t know the details to give more help on that.
>
> One other factor, I have braided stainless hoses, that are smaller OD and ID
> than stock rubber hoses.
>
>
> > On Apr 24, 2022, at 12:28 PM, Jay <jay.laifman@gmail.com> wrote:
> >
> > On my drive today, I first noticed that when slowing to a stop, at the very
> > last moment before stopping, the brakes seemed to have an extra bite. I
> > didnâ??t notice anything at speed or during braking. Just that last
> > moment. But once I lifted, it always stopped. Then at one point, it
> > seemed like it was biting a bit more. Again, the second I lifted off the
> > brakes it was fine.
> >
> > Thoughts?
> >
> > This is with stock brakes and servo.
> >
> > I almost want to say that it is only one front wheel. But Iâ??m not sure.
> > That would suggest caliper or hose. But when those stick or bite, I
> > donâ??t know that they release the second the pressure on the pedal is
> > released.
>
>
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
>
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/garywinblad@comcast.net
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|