--===============8126371635372444169==
--000000000000ae17970582ae9d88
Hi,
I got into my distributor (FoMoCo 12127) to replace the points with a
Pertronix unit and I decided to strip the whole thing down because the
shaft was not turning easily (dried out gunk). I made note of where the
springs and weights went on the cam and stop plates but I didn't make a
note of which slot in the cam plate goes over the tab that limits the
advance. One slot is marked 13L (which I believe means 26 degrees of
advance) and the other slot is marked 18L (which I believe means a limit of
36 degrees). The manual says a max centrifugal advance of 11 degrees. So,
should I set the plate to 13L for a max advance of 26?
Thanks,
Joe Brown
--000000000000ae17970582ae9d88
Content-Transfer-Encoding: quoted-printable
<div dir=3D"ltr">Hi,<div><br></div><div>I got into my distributor (FoMoCo 1=
2127) to replace the points with a Pertronix unit and I decided to strip th=
e whole thing down because the shaft was not turning easily (dried out gunk=
).=C2=A0 I made note of where the springs and weights went on the cam and s=
top plates but I didn't make a note of which slot in the cam plate goes=
over the tab that limits the advance.=C2=A0 One slot is marked 13L (which =
I believe means 26 degrees of advance) and the other slot is marked 18L (wh=
ich I believe means a limit of 36 degrees).=C2=A0 The manual says a max cen=
trifugal advance of 11 degrees.=C2=A0 So, should I set the plate to 13L for=
a max advance of 26?</div><div><br></div><div>Thanks,</div><div>Joe Brown<=
/div></div>
--000000000000ae17970582ae9d88--
--===============8126371635372444169==
Content-Transfer-Encoding: 7bit
Content-Disposition: inline
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
--===============8126371635372444169==--
|