Iâ??ve used a lot of different gasket material over the years and even made my
own but, for me, cork is the way to go. I apply contact cement to the valve
cover side and thatâ??s it. Makes it easy to remove and replace without using
a new gasket. Never had any leakage problems.
Jim
> On Feb 8, 2019, at 7:29 PM, Joe Brown via Tigers <tigers@autox.team.net>
> wrote:
>
> Hi,
>
> I'm looking for recommendations for valve cover gaskets that fit well with
> the LAT 8 covers. The gaskets that came in my set from Fel Pro are molded to
> fit the stamped valve covers and hang way out over the edges of the aluminum
> covers. The LAT 8 covers are flat on the gasket surface so I guess I would
> be looking for something like a flat cork gasket but I'm hoping there is
> something better out there than just cork.
>
> Thanks,
> Joe Brown
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
>
> Unsubscribe: http://autox.team.net/mailman/options/tigers/jbsyv@yahoo.com
>
>
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|