BTW, I did not state the minimum rotor thickness number.
I have never seen a ROOTES FACTORY dimension for the minimum.
As far as I know, IF the rotor needed turning, it was recommended to
replace it.
That being said, it is common for OTHER rotors of the same thickness
(1/2") to have a minimum thickness around .440 ...I think..??
(.....if I could remember things, I would REALLY be dangerous...)
...or ONLY around .060 (or some metric number close) off, max.
.375 IS TOO thin IMHO.....THAT I DO remember.
YOUR thickness may very....
DW
____________________________________________________________
Want to place your ad here?
Advertise on United Online
http://thirdpartyoffers.juno.com/TGL3141/55f71b6746eba1b67482dst01vuc
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|