Gary
Thank you for the pictures.
The 1st picture is the front right side corner of the block. This one I
removed from my Tiger for closer examination plus it needs a little TLC
restoration. The bracket is the Angle, 7/16" UNC bolt, "R" clip, screw, nut
and all the washers.
2nd picture is the bracket at the rear of the engine. Thanks much for that
one. My Tiger is not in a position to be jacked up. I will pass that
picture on the Andy Walker.
Parts List shows the C3OZ-A bracket for the Mk I. My thought is that it
would mount to one of the timing cover bolts.
I don't think I have ever seen a bracket at the front of the engine but we
need to explore that avenue.
Ron Fraser
-----Original Message-----
From: Gary Winblad [mailto:garywinblad@comcast.net]
Sent: Friday, February 06, 2015 11:46 AM
To: rfraser@bluefrog.com
Cc: tigers@autox.team.net
Subject: Re: [Tigers] Fuel line Brackets
Ron,
Attached are two lousy photos of the two fuel brackets still existing on
B9470585 (it is hardly stock so..) I don't think I have ever seen a bracket
from the water pump bolt. Could it be that the one at the front of the
engine is in the parts list as the last two pieces that you show. It IS two
pieces, one is an "angle" and one IS a "clip and screw". Gary
----- Original Message -----
From: Ron Fraser via Tigers <tigers@autox.team.net>
To: tigers@autox.team.net
Sent: Fri, 06 Feb 2015 15:53:25 -0000 (UTC)
Subject: [Tigers] Fuel line Brackets
There has been a discussion about the fuel line brackets for the Tiger
engines.
Parts List indicates 3 brackets mounted to the Tiger engines.
@ the rear of the engine
1224792 Plate - Pipe carrier
9116027 Grommet Mk I
9176015 Grommet Mk II
@ the right side front corner of the block
1224791 Angle - Pipe clip support Superseded by 1229865
1229865 Angle
@ the front of the engine
6100292 C3OZ-9180-A Mk I
6100909 Mk II
National Parts Depot lists 3 different fuel line brackets.
Bob Mannel confirmed that # 9180-0A is a reproduction of the C3OZ-A part.
This part was mounted under one of the water pump bolts and painted satin
black with the engine; the clip and screw were natural color. I don't know
if painted is correct for the Tiger engine.
NPD part #9180-1A is the 1965 bracket and #9180-1B is the 1966 bracket.
Anyone have an original fuel line bracket mounted to the front of their
engine?
Which bolt is it under?
Which style bracket was used on the Mk II engine?
Ron Fraser
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|