Paul
Very interesting! I think I have that bracket on my Tiger but not
sure at this moment without looking.
I believe that bracket is C3OZ-9180-A.
Ron Fraser
-----Original Message-----
From: Tigers [mailto:tigers-bounces@autox.team.net] On Behalf Of
ironbeast--- via Tigers
Sent: Monday, February 02, 2015 5:39 PM
To: undisclosed-recipients:
Cc: LIST TIGER
Subject: Re: [Tigers] Fuel line support bracket
Andy,
There is another metal bracket that mounts to a bolt in the block at the
front corner of the engine. Its attached with a horizontal bolt near where
the dipstick enters. If I ever replaced it I might try to make it out of
phenolic or some material that would better insulate the fuel line from the
block.
I can attempt a photo to take a if that might help.
Regards,
Paul.
----- Original Message -----
From: "awtiger--- via Tigers" <tigers@autox.team.net>
To: "Tom Parker" <tkparker1941@gmail.com>
Cc: "LIST TIGER" <tigers@autox.team.net>
Sent: Monday, February 2, 2015 1:56:58 PM
Subject: Re: [Tigers] Fuel line support bracket
Tom:
Thank you so much for the picture; I hope it wasn't too much trouble. That
will certainly help me, however, with my fuel line routing. I take it that
is the only bracket on the line? Is there no means of support as the line
passes the side and/or front of the engine? If not, I would just assume it
would hang from the fuel filter connection with the carburetor feeder line,
right?
Thanks again,
Andy
---- Tom Parker <tkparker1941@gmail.com> wrote:
> I had the original steel lines, and when I installed the stainless
> fuel
> lines I (more or less) followed the original contours. To keep the line
> away from the exhaust they routed it below the starter and up along the
oil
> pan to the front of the engine.
>
> Tom
>
>
> On Mon, Feb 2, 2015 at 12:56 PM, Tom Parker <tkparker1941@gmail.com>
> wrote:
>
> > Correction: it;s off the lower starter motor bolt. Picture should
> > show up
> > soon.
> >
> > Tom
> >
> > On Mon, Feb 2, 2015 at 12:38 PM, Tom Parker <tkparker1941@gmail.com>
> > wrote:
> >
> >> Andy, Yeah, a bracket hanging off the bellhousing. It'll take a bit
> >> of
> >> work, but if you need it, I can get a picture.
> >>
> >> Tom
> >> '67 Mark 2
> >>
> >> On Mon, Feb 2, 2015 at 12:04 PM, awtiger--- via Tigers <
> >> tigers@autox.team.net> wrote:
> >>
> >>> Hey, guys:
> >>>
> >>> My question deals with the under-engine metal fuel line that runs
> >>> from
> >>> the bell housing area on the passenger side of the car and curves
upward in
> >>> front of the engine to the fuel filter. Isn't there supposed to be
some
> >>> kind of bracketry involved in holding this line in place? The damn
> >>> (dumb...whatever...) previous owner must have figured that it would be
> >>> "good enough" to zip-tie the fuel line to the hydraulic brake line
that
> >>> runs along the front suspension crossmember. I've looked in the
factory
> >>> parts manual for an illustration but there is none. Can anyone shed
some
> >>> light on how this fuel line is supported?
> >>>
> >>> As always, thanks a million,
> >>> Andy Walker
> >>> Edmond, OK
> >>> B382001600LRXFE
> >>> TAC #740
> >>> _______________________________________________
> >>>
> >>> tigers@autox.team.net
> >>>
> >>> Donate: http://www.team.net/donate.html
> >>> Archive: http://www.team.net/archive
> >>> Forums: http://www.team.net/forums
> >>> Unsubscribe:
> >>> http://autox.team.net/mailman/options/tigers/tkparker1941@gmail.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/ironbeast@comcast.net
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2015.0.5645 / Virus Database: 4273/9045 - Release Date: 02/02/15
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|