Terry
This was a topic back in Jan this year. I'll have to look to see
what information is there.
Here is a note I wrote:
There is a shim listed in the Alpine Parts List in the SI & SII section; pg
YV11.
2201875 Shim - Toggle Catch
I don't see it listed anywhere else so no idea if it is a continuation part
beyond this point or if there is another part number for the shim used
later.
I did some searching through my parts piles and found 1.
It is a cast aluminum part. Looks like they may have been cast in pairs
then cut across the thick part of the wedge.
1.32" x .79"
Wedge .128" to .045
2 slots - .24" x .485"
Ron Fraser
-----Original Message-----
From: Tigers [mailto:tigers-bounces@autox.team.net] On Behalf Of Terry
Packer
Sent: Saturday, September 06, 2014 6:46 PM
To: TIGERS@AUTOX.TEAM.NET
Subject: [Tigers] Roof Latch Shims?
Hello All
I
hope someone can answer a few questions
regarding the wedge shaped shims which should reside between the
soft-top latches and the top's front bow. They were installed to improve
alignment of the tongue on the latch with the receiver on the
windshield headrail.
Anyone:
1) know where replacements can be purchased? SS doesn't carry them.
2) have an original from which you could supply dimensions or at least a pic
or two?
3) have any tips on fabricating a replacement? Is there a look-a-like part
or material that makes a good starting point?
4) confirm whether these shims were installed under the latches of both soft
and hard tops?
Thanks
Terry Packer9470018 _______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|