I'm in the 'no original Clear Hooters installation' camp, so I've resisted
commenting up to now. I did at some point acquire some that had the original
bracketry attached, so it was possible to try the horns on each side and see
what made sense. If I installed them one way, the trumpets faced straight
forward. That might seem to be a good way to get good sound, but then I
realized that they'd also make great bug catchers that way. So I installed
them the other way, where the trumpets are canted inward about 60 degrees.
Then I installed horn-hole blockoff plates but I made up mounts that went off
the blockoff plates, that preserved the original angles - they just push the
horns ahead by a couple of inches.
I did find that it was necessary to take the horns apart, clean up the points,
and then reassemble them and adjust the current to spec, to make them work
reliably... and that I had to install a relay to actuate the horns because the
horn ring circuit on the steering wheel had way too much resistance to
actually properly drive the horns. Now, they are good... I can look to see
what I have on which side, but I can't vouch for originality.
Theo
________________________________
CONFIDENTIALITY NOTICE: This email and any attachments are for the sole use of
the intended recipient(s) and contain information that may be confidential
and/or legally privileged. If you have received this email in error, please
notify the sender by reply email and delete the message. Any disclosure,
copying, distribution or use of this communication (including attachments) by
someone other than the intended recipient is prohibited. Thank you.
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|