Joel
Cables - used parts dealer or make your own - bicycle parts maybe
Heater control cable - 1201379
Air control cable - 1206478
Elbow - 2201362 used part dealer
Tonneau studs - I believe there are at least 2 different configurations as
to where the studs go. You would need a Tonneau cover and then place the
studs where needed. You might be able to see the position for the studs
from under the dash.
My Tiger has 2 studs center of the dash pad about 3" back from the
windshield and 2 studs near the doors again about 3" back from the
windshield.
Motif - there should be 3 barrel clip holding the surround - you should be
able to gently pry the surround up and off the body. Plastic badges can be
cleaned and the polished with plastic polish as needed.
Ron Fraser
-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of Joel Martin
Sent: Tuesday, October 01, 2013 2:06 PM
To: Tiger List Serve
Cc: Rick McLeod - Sunbeam Specialties
Subject: [Tigers] Parts Questions
All
I find no heater control cables listed in SS catalog. Does anyone know of a
source and part numbers for the 2 cables? My car did not have a heater when
acquired.
Does anyone have a 'elbow' (part # 17) that they would be willing to part
with that goes on the end of the defroster hose?
I think on
the black metal defroster vents (2) - that go on top of the dash pad, there
should be tonneau studs used (SS part # AT73 on page 20, soft top
fasteners), how many are used and where do they go?
ET66 Chrome surround for motif badge
-'Sunbeam V8', what is the best way to get the motif out and clean up -
black paint on back side?
Thanks
Joel Martin
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|