tigers
[Top] [All Lists]

Re: [Tigers] Pertronix / MSD Coil

To: Thomas Witt <atwittsend@verizon.net>
Subject: Re: [Tigers] Pertronix / MSD Coil
From: Mark Rense <mark44124@gmail.com>
Date: Sat, 3 Aug 2013 13:56:53 -0400
Cc: "tigers@autox.team.net" <tigers@autox.team.net>
Delivered-to: mharc@autox.team.net
Delivered-to: tigers@autox.team.net
References: <3006D8E78E2742ABB46EC632568F05E1@optiplex3301>
I guess my first question is why mix and match? Pertronix makes coils for
both the original and higher output coils for the II and III. I have gone
to their III system on several cars, they are more robust than the original
and include a nice rev limiter.

Run it straight with no ballast resistor.
On Saturday, August 3, 2013, Thomas Witt wrote:

> Not a Tiger application in my case - but..., I know  quite a few of the
> Tiger
> folks are running the Pertronix ignition module ( the original version in
> my
> case). Are any of you running the MSD Blaster 2 coil (8203)?  I am not
> planning to use the MSD box, only the Pertronix and the MSD coil.  I've
> read
> on the internet where some have no issues at all. However, there are those
> who
> say that Pertonix told them NOT to use the MSD coil.
>
> So, it is a bit confusing. If you have had success with the combination I'm
> planning, I'd like to hear from you.  Also, I'd like to know if you use a
> ballast resistor.  MSD says the resistor, .8 ohms, is only needed for
> points.
>
> Thanks, Tom
> _______________________________________________
>
> tigers@autox.team.net <javascript:;>
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/mark44124@gmail.com
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>