tigers
[Top] [All Lists]

Re: [Tigers] Carb install - at least it's not leaking

To: <jay.laifman@gmail.com>, <michael@michaelshortt.com>
Subject: Re: [Tigers] Carb install - at least it's not leaking
From: " Ron Fraser" <rfraser@bluefrog.com>
Date: Sun, 16 Jun 2013 15:07:36 -0400
Cc: tigers@autox.team.net
Delivered-to: mharc@autox.team.net
Delivered-to: tigers@autox.team.net
Thread-index: Ac5qwWoA2FCn3VC6Rpq2tgLP95E2dQAAWwkg engine=2.50.10432:5.10.8794,1.0.431,0.0.0000 definitions=2013-06-16_07:2013-06-14,2013-06-16,1970-01-01 signatures=0 spamscore=0 suspectscore=2 phishscore=0 adultscore=0 bulkscore=0 classifier=spam adjust=0 reason=mlx scancount=1 engine=7.0.1-1305240000 definitions=main-1306160207
Jay
        My Holley Haynes Techbook does not list this problem.
Something in the idle circuit is not right.

Check to see if the secondary throttle plates are closed

Vacuum choke? - Are you sure its usually vacuum secondaries
Choke is normally electric or heat stove pipe style with bi-metal spring

check to make sure there are no vacuum leaks

Ron Fraser

-----Original Message-----
From: tigers-bounces@autox.team.net [mailto:tigers-bounces@autox.team.net]
On Behalf Of jay.laifman@gmail.com
Sent: Sunday, June 16, 2013 2:43 PM
To: michael@michaelshortt.com
Cc: tigers@autox.team.net Den
Subject: Re: [Tigers] Carb install - at least it's not leaking


Vacuum choke. Good idea though. Thanks.
Sent from my Verizon Wireless BlackBerry

-----Original Message-----
From: "michael@michaelshortt.com" <michaelsavga@gmail.com>
Date: Sun, 16 Jun 2013 14:27:23
To: Jay Laifman<jay.laifman@gmail.com>
Cc: tigers@autox.team.net Den<tigers@autox.team.net>
Subject: Re: [Tigers] Carb install - at least it's not leaking

Is that an electric choke? Have you confirmed that power is going to it?

Michael


On Sun, Jun 16, 2013 at 2:19 PM, Jay Laifman <jay.laifman@gmail.com> wrote:

> Got it all back together and went for a drive.
>
> Like I said, the good news is that it is not leaking gas anymore.
>
> The bad news is that it doesn't want to run below 2,000 rpm.  As it
> warmed up, it seemed like the rpm range needed to be even higher.  I
> basically had to keep the rpm above 2,000 or 2,500 at all times or it
> stalled.
>
> Any thoughts on what I've done wrong?
>
> One thing I don't fully understand, and perhaps it is part of the
> problem, the rectangular flap that is part of the choke, it seems to
> be open all the time.
> I would have thought that when the car was cold, it would be closer to
> closed.
> Maybe I flipped something when I put that back together.  But, even with
> wide
> open, once the engine was warm, I would have thought it would run fine.
>
> Over 2,500, it was nice, smooth and powerful.
>
> Thanks for any thoughts.
>
> And Happy Father's Day to all the fathers out there.
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/michael@michaelshortt.com
>
>
>


--







Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael@michaelshortt.com
912-232-9390


This email is protected by the Electronic Communications Privacy Act, 18
U.S.C. Sec. 2510-2521, is confidential and may be legally privileged.  If
you are not the intended recipient, you are hereby notified that any
retention, dissemination, distribution or copying of this communication is
strictly prohibited.  Please reply to the sender that you have received this
message in error, then delete it.  Thank you
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
_______________________________________________

tigers@autox.team.net

Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net


<Prev in Thread] Current Thread [Next in Thread>