Best recipe for a solution to loosen stuck bolts is 50% benzene and 50% ATF,
it is quite volatile, just make as much as you need, you can't or shouldn't
keep it stored.
Michael Shortt
On Mon, Jun 10, 2013 at 5:23 PM, Chris Thompson <chris@cthompson.net> wrote:
> I've got sockets that go up over two inches or so (heavy equipment) -
> what's so weird? Was it 1/2" drive or something?
>
> Chris
> B382000331
>
>
> On 6/10/2013 5:16 PM, Smit, Theo wrote:
>
>> That would be for the Tiger's rear axle nuts. 125 or 150 foot-pounds
>> torque
>> spec IIRC... you definitely need the big breaker bar to go along with that
>> socket.
>>
>> Theo
>>
> ______________________________**_________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.**html<http://www.team.net/donate.html>
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/**options/tigers/michael@**
> michaelshortt.com<http://autox.team.net/mailman/options/tigers/michael@michaelshortt.com>
>
>
>
--
Michael L. Shortt
Savannah, Georgia
www.michaelshortt.com
michael@michaelshortt.com
912-232-9390
This email is protected by the Electronic Communications Privacy
Act, 18 U.S.C. Sec. 2510-2521, is confidential and may be legally
privileged. If you are not the intended recipient, you are hereby notified
that any retention, dissemination, distribution or copying of this
communication is strictly prohibited. Please reply to the sender that you
have received this message in error, then delete it. Thank you
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|