I've done the various tests to confirm that it is the ignition switch that is
not allowing enough power to get to the starter solenoid.
I searched the archives and found some comments like "find a way to open it up
and clean the contacts." But, I never found anyone say that was actually
possible. I saw others that said when the switch goes it has to be replaced -
with no mention of repair.
I guess I'll pull it off the car tomorrow anyway and see if there is anything
obvious about pulling it open.
I did see posts about putting the key in and using a paperclip or something in
some hole to remove the barrel so that the key can be used in a replacement
switch. I hope this is still possible.
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|