Details from my factory original trunk floor:
Hangers at bulkhead are attached at top of wood and covered by floor vinyl.
Hanger attachment is by Phillips type ("Posi-drive"?) round head bolts ( I know
it is that type of bolt because one bolt head has been worn through the
vinyl...)
Nut and washer on bottom side of floor .
Wood is 5 layer plywood approximately 5/16 thick.
Gene .
----- Original Message -----
From: "Curt Hoffman" <choffman9@cinci.rr.com>
To: tigers@autox.team.net
Sent: Sunday, February 3, 2013 2:59:15 PM
Subject: [Tigers] Truck bracket location
I am making a new plywood trunk "floor" for my Tiger. Wanted to check stock
installation since I am not sure the one that is in my car is original.
Do the brackets that support the floor and hang off the front bulkhead mount
on top of the plywood and get covered by the vinyl, or do they mount
underneath the plywood and are exposed when you lift the plywood floor?
Thanks,
Curt
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe:
http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
_______________________________________________
tigers@autox.team.net
Archive: http://www.team.net/archive
Unsubscribe: http://autox.team.net/mailman/options/tigers/mharc@autox.team.net
|