Nathan,
First check that the block adapter is thin enough to fit behind the headers,
Been there bought several until I found a thin one. Dale A.
Had one but it was pricey. The stock one fits, but you have to use tubing
flare fittings.
My filter was installed behind the drivers head light bucket. It bolts to the
inner fender panel.
The holes for the hoses are just behind the Coolant reservoir, high up, just
below the step for the hood.
I used ss braided hose and AN fittings. I needed one fitting with a slight
angle to clear the steering shaft.
I can shoot some pix this weekend.
Erich
---- Nathan Johnson <vesselofgrace@hotmail.com> wrote:
> I'm looking to install a oil filter remote setup I bought off of Summit due to
> putting headers in my Tiger. I get the impression that a lot of people have
> relocated their filter to the front left wheel well and I was wondering if
> anyone on the list had some pics of where and how they mounted their remote to
> better assist me in determining exactly where I should be cutting holes.
>
> Thanks,
>
> Nathan Johnson
> _______________________________________________
>
> tigers@autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/e.coiner@cox.net
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/tigers-archive@autox.team.net
|