If you were to flush the system with a brake cleaning solvent, then you need
to expose it to air to allow that fluid to evaporate... however, if you use
compressed air to blow the lines out then you need to consider that the output
of the air compressor will have compressor oil in it, as well as moisture from
the air; so you may be putting in more contaminants than you're getting out,
unless you have both a filter and a dryer on your compressor output.
On balance it would seem to be better to flush with clean brake fluid.
Theo
This e-mail and any attachments may contain confidential material for the sole
use of the intended recipient. If you are not the intended recipient, please
be aware that any disclosure, copying, distribution or use of this e-mail or
any attachment is prohibited. If you have received this e-mail in error,
please contact the sender and delete all copies.
Thank you for your cooperation.
_______________________________________________
tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|