Hi Tod, I am working on my seats too. That spring is not so small by my
standards. I measure it overall outside length to be 4.99 inches, say 5 for
practical purposes. The length of of the coiled section is 3.515 inches.B The
cross dimension of the coiled section measures 0.756 inch ,B so say 3/4 inch
.B The diameter of the wire it is made out of is 0.105 inches.B Very strong
tension, as you would expect with that thick of a coil material. Let me know
if a pic would be helpful or there is anything else you need.
Cheers,B Gene
----- Original Message -----
From: "Tod Brown" <todbrown@roadrunner.com>
To: Tigers@autox.team.net
Sent: Friday, April 22, 2011 1:53:15 PM
Subject: [Tigers] Seat Springs
In the process of redoing the upholstery on my seats, I discovered that
the small spring that tensions the lever to adjust the seat back angle
is missing on both the seats (Part #193 on Plate B, Section YX in the
Alpine Parts Manual). B I figure I can get them at my local hardware
store, but I need to know a little bit about the length and diameter to
make a good choice. B Anybody have one they could take a look at and make
some measurements? B Thanks in advance.
Tod
B382002384LRXFE
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage:
http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
_______________________________________________
Tigers@autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
|